Table of Contents
A completely clogged drains must be the subject of a rapid intervention. Professionals can fix it more effectively. Because drains block is not a simple issue it’s quite complicated issue. If the clogged is just a minor it will unclogged with following tricks. Following are useful tricks that helpful for a minor blockage.
The hanger trick
Take a regular wire coat hanger and straighten it out as you can. Then bend one end over to create a small hook. Remove the cover from your pipe and start fishing. You should be able to get all sorts of “materials” and different residues that have clogged your drain. Once you have collected as much residue as possible, pour hot water down the drain. Thus, you can once again have a pipeline free of any obstacles.
The wet and dry vacuum cleaner
If you have a wet and dry vacuum, it can be a great tool for unblocking your drain. First, put it under vacuum clogged drains. Next, create the tightest seal possible on the pipe. You can try adapting an old plunger head for this purpose. With the vacuum turned to its highest setting, the suction can be strong enough to pull the clog out of the drain. It doesn’t always work, but it’s worth a try.
The boiling water technique
Boil water and pour it slowly down the drain in two or three stages, allowing the hot water to work for several seconds between each pour. This is usually the easiest and fastest way to unblock a clogged drain.
The use of caustic soda
For this trick, consider using rubber gloves and eye protection. Caustic soda (also known as sodium hydroxide) or lye can cause nasty chemical burns. So always be careful when handling it. Pour 3/4 liter of cold water into a bucket, then add 3 cups of caustic soda. Stir well with an old wooden spoon. The mixture will then begin to emulsify and heat up. Pour down the clogged drain and leave for 20-30 minutes, then flush your drain with boiling water. Repeat the operation if necessary.
Place an empty bucket under the U-pipe (the trap) under the sink. The bucket will collect the water that will spill out. Using a plumber’s wrench, loosen the nuts on both ends of the pipe. You will need to be able to complete the operation manually. When the trap is free, remove it and turn it over, emptying the contents into the bucket. You may also need to dig out some debris from inside the pipe. An old toothbrush is a good idea for removing hard dirt. Rinse the trap with water and then put it back in place.
Conclusion: these tips are useful but if these are not working you cam call NRC Gravco to reduce future frequently unclogged cost. Because they do clean with the experience of year and also use high quality machines that do it more efficiently.